What kind of set up should I run from the headers back?
i have a borla exhaust on there now, but I am not against pulling it off and running dumps.
I am open to suggestions for this setup.
Please help me with this guys, also, please give me some web links for the parts to order. thanks a bunch!!!!!

 

Just weld some dumps onto some collectors and bolt them onto the header collectors

 

Leave that Borla on there, and if you want louder, go get yourself a cutout. With the cutout, you get the same (if not better) gains compared to true duals, and for much less money. Just my opinion. Good luck.

 

I just do not know what to do, I am wanting to do something that is not that radical, like dumping, but then again, I like em loud

Can someone point me in the direction of the collectors/y pipe needed for the dynatechs? Please?

 

Man i was just screwin around, you wouldnt be able to see anything your eyes would be shaking, you have to weld some collectors (just the universal 3-bolt flanged collectors) onto some 2.5" or 3" pipe, then into some dynomax bullet mufflers, then into dumps before the axles, if you take it to a muffler shop they will know what to do.

 

So, basically, some flanged 3 inch collectors, some 3 inch bullets and some stainless spipe and I should be in good shape?

 

Exactly, dont forget the dumps. If you want to spend a little more and less interior noise, you can have them bend it over the axles out the back.

 

go with a custom 3" Y for the Dynatech's...$90-$100 installed...

 

then just install 2 cutouts, one after each header...and you'll be set