where can you get an electric cutout

 

check the for sale forum there have been a few on there lately.

 

i shouldt just get a cutout

 

also none said if it would shake the inside of my car

 

If you get a manual exhaust cutout and run it open all the time there will be a loud (depending on placement) drone inside the car and it can be pretty anoying for daily driving. The sound when you get on it is quite impressive though The soultion is of course an electric cutout but the electric valve can be expensive (about 179$ or so if I remember correctly).

 

I had the same setup before my borla. loved it at first, but it didnt satisfy me

 

I would say go with the Dynomax. i have two dumped before the axle and I have no drone inside the car. So one at the back will have a nice deep tone and no drone.

 

ok then i am gonna get that exhaust set up

 

Do they make a bullet that has a 3" inlet and a 2 1/2" outlet? If so ill just put that in place of my flowmaster. How loud would that be compared to a Loudmouth? The car has headers no cats. Thanks

 

no they dont and it is louder then the loudmouth and sounds better

 

You could get a 3" to 2.5" reducer after the bullet.

No, the inside of your car will not shake. You have a chance of that happening if you got a poly tranny mount. If your car is stock, I would not worry about it.
Shaking usually comes from big cams or poly mounts.

I would say to not go with a cutout. Simply because the unmuffled sound is quite annoying for daily driving, and when you close the cutout, its simply not satisfying enough. Bullet muffler is the best way to go, hands down.

 

You could get a 3" to 2.5" reducer after the bullet.

why should i do that ???

 

That response was for the person who asked if he could put a bullet muffler in place of his flowmaster.

 

oh ok