Dynatech LTs, Are Over-The-valvecover Wires needed???
Registered User
Joined: Nov 2001
Posts: 3,515
From: Kansas
they will save you from burning wires and posting on here how you have a mysterious low RPM stumble and high RPM miss
and as said above... they look cool! ill just say either you buy them now or you buy them later... there might even be a group purchase still going on from thunder racing so check that out.
and as said above... they look cool! ill just say either you buy them now or you buy them later... there might even be a group purchase still going on from thunder racing so check that out.
Registered User
Joined: Dec 1999
Posts: 825
From: Houston, TX
They aren't absolutely necessary, but I'd recommend replacing your wires and routing them over the valve covers. If you do choose to keep the stock wires, watch out for the #6 plug boot and wire, it will touch the header if your not careful. #6 is the wire I burned right after my headers were installed, I then went over the valve covers.
Thread Starter
Registered User
Joined: Feb 2002
Posts: 1,106
From: Toledo, Ohio USA
Originally posted by EviLBoX
They aren't absolutely necessary, but I'd recommend replacing your wires and routing them over the valve covers. If you do choose to keep the stock wires, watch out for the #6 plug boot and wire, it will touch the header if your not careful. #6 is the wire I burned right after my headers were installed, I then went over the valve covers.
They aren't absolutely necessary, but I'd recommend replacing your wires and routing them over the valve covers. If you do choose to keep the stock wires, watch out for the #6 plug boot and wire, it will touch the header if your not careful. #6 is the wire I burned right after my headers were installed, I then went over the valve covers.
Thread
Thread Starter
Forum
Replies
Last Post
