CRS E/WP Problem
Thread Starter
Registered User
Joined: Nov 2005
Posts: 646
From: PA
CRS E/WP Problem
well i ran into my first problem with my WP today. 1200 miles after install...
I did an inspection under the hood and noticed that 3 of the 4 hex socket head screws on the front had loosened up. One was totaly unthreaded and the other 2 were about 1/4" out.
so i put locktight on them and tightened back up.
just something to look out for if you own one.
I did an inspection under the hood and noticed that 3 of the 4 hex socket head screws on the front had loosened up. One was totaly unthreaded and the other 2 were about 1/4" out.
so i put locktight on them and tightened back up.
just something to look out for if you own one.
Last edited by ZL1modified; Jul 26, 2006 at 09:16 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Magenta_Hearts
New Member Introduction
4
Mar 25, 2015 10:24 AM
