crank/ hub problem

Reply Subscribe

Thread Tools

Search this Thread

Apr 19, 2003 | 01:50 PM

Max 93

Thread Starter

Registered User

Joined: Jun 2001

Posts: 406

From: New Berlin, WI USA

crank/ hub problem

Has anyone had a problem getting the hub to go on to a Scat crank? it seems as though the crank is too big for the hub. I have tried an aftermarket and factory hub. Any ideas on how to get this thing on there?

Apr 19, 2003 | 02:12 PM

SDAKOVIC

Registered User

Joined: Dec 2002

Posts: 221

From: Osceola,Wi.

first i would use a caliper and measure both. that might give you the answer your looking for. also measure old crank if you still have it.

Apr 20, 2003 | 10:36 AM

Max 93

Thread Starter

Registered User

Joined: Jun 2001

Posts: 406

From: New Berlin, WI USA

Apr 20, 2003 | 10:48 AM

TonyJ

Registered User

Joined: Apr 1999

Posts: 514

From: Boulder, CO USA

Well, assuming it's the correct size, just tight, I've read that some people heat the hub up in the oven to get it to expand and then it slips on easily. Use oven mits, though...