Clip holding TO bearing on new PP.
Thread Starter
Registered User
Joined: May 2002
Posts: 1,025
From: Saskatchewan, Canada
Clip holding TO bearing on new PP.
Hey guys I was just wondering that if I should remove the clip that holds the TO bearing on the PP when I install the clutch tommorow? Its a Spec Stage 3 ceramic if that helps any. If you dont know what Iam talking about goto http://www.ws6.com/slpclutc.htm and look at the last picture on the bottom of the page. See the TO bearing on the PP? See the clip that holds it on? Should I remove that before I put the tranny back on? I noticed on the bottom of the page that it fell out on that guy but I just wanted some extra opinions just in case. THanx for the help!
Thread
Thread Starter
Forum
Replies
Last Post
350350
Fuel and Ignition
14
Aug 11, 2015 12:03 PM