I am gonna change that tomorrow. I looked in the haynes manual some, but did not find anything about it. What is the best way for me to change this. Thanks for any help.

James

 

Not much to it. Make some room so you can get to it. unplug it and then remove the module and clean the heat transfer grease off. Your new module should come with new grease. Don't install it without it! Just spread a layer of the grease on the bottom of the module and carefully put it back on. Don't overtighten the screws.

 

Thanks, I am about to get to it now.

 

Well I changed the module and the car will still not start. I am gonna get under the car later to see if I am getting any spark, or what ever you call it, from the starter, then the coil, and anything else I can think of. I am checking all of this with one of the tools that have the light that lights up. Wish me luck on finding out the problem.