CC306 Rev Limiter???
Thread Starter
Registered User
Joined: Jan 2006
Posts: 521
From: Bryant, Arkansas
CC306 Rev Limiter???
Im installing the CC306 in my stock bottom end motor. Has 1.6 Roller rockers, Hardened pushrods, valve springs, TH350... etc.
What should I set my Rev limiter at???
Also, I will be stock heads for now...
One more question... Do you recommend PCMforLess???
If not, who?
thanks
What should I set my Rev limiter at???
Also, I will be stock heads for now...
One more question... Do you recommend PCMforLess???
If not, who?
thanks
Registered User
Joined: Jan 2004
Posts: 358
From: Texas
Mine is 6800 I heard the cam can pull to 6700 not sure though maybe someone can confirm this. What kinda springs are you using? I went for a MadZ28 tune myself. I'm sure they'll both work either way, but since you're running stock heads I think the motor is gonna starve up top. I'm not really an engine guru so I can't tell you for sure.
Registered User
Joined: Feb 2007
Posts: 322
From: mechanicville n/y
mine was at 6800 till i nitrous nuked it 
oh well it will pull till bout 6500 on stock heads then run out pcmforless did my tune hit it about dead on just be very specifac when u tell him what ya want
oh well it will pull till bout 6500 on stock heads then run out pcmforless did my tune hit it about dead on just be very specifac when u tell him what ya want
Thread
Thread Starter
Forum
Replies
Last Post
