Ok I did a search on these headers and didn't find anything with people reccomending wires to be used with these headers.

I was thinking either a new set of stock wires, or some Accel extreme 9000's

Don't want the OTVC ones, too much of a hassle for me. I wanna get them done by the weekend. Plus I can run to summit tomorrow to get the accels if need be

 

I use Magnecor wires. They offer a set cut slightly longer than stock, intended specifically for F-Bodies with headers. They are expensive, however. I bought mine through Thunder Racing, and later found that Lingenfelter had a better price. (That's a first !)

There was a thread last week about AS&Ms that eventually settled on a discussion of wires and how to safely route them. Most people, myself included, had found that the OVC was not necessary.

 

i too have as&m headers, i would recommend any wire that is longer than the stock, i have msd wires and had to make a wire for #8

can you run otvc wiring with as&m, looking at the primary for #2 runs close to the flange, just looked like a tight area for wiring

 

I saw those. I was also looking at the Taylor Spiro-Pro 8mm's, summit has them for under $50.

If by chance you have the link to that thread, could you post it? I'm gonna try to find it

 

Here's the thread I referred to:

http://web.camaross.com/forums/showt...ghlight=as%26m