Wiring up a DMH Electric Cutout
Thread Starter
Registered User
Joined: Oct 2003
Posts: 1,276
From: Chattanoga & Franklin
Wiring up a DMH Electric Cutout
Just bought my DMH cutout using a GP on the site.
My buddy knows how to weld, so we'll be putting in ourselves.
How big of a PTA is the wiring for one of these? I think it comes with instructions, but has anybody wired one of these before?
My buddy knows how to weld, so we'll be putting in ourselves.
How big of a PTA is the wiring for one of these? I think it comes with instructions, but has anybody wired one of these before?
Registered User
Joined: Sep 1998
Posts: 8,319
From: US 1 Mile Marker 52 in the Florida Keys
if it's anything like my QTP it should just be connect the ground, connect to a 12v source and snake the wires to where you want to have the switch.
it should come with everything needed.
and there is a gromet near the back passenger seat floorpan to run the wires into the interior i beleive
it should come with everything needed.
and there is a gromet near the back passenger seat floorpan to run the wires into the interior i beleive
Registered User
Joined: Sep 1998
Posts: 8,319
From: US 1 Mile Marker 52 in the Florida Keys
no man...
i still havn't installed my cutout plate so i'm not 100% sure, but i've been told there IS a grommet to go through.
worse case you could run the wires up and into the interior around the shifter...that was my backup plan
i still havn't installed my cutout plate so i'm not 100% sure, but i've been told there IS a grommet to go through.
worse case you could run the wires up and into the interior around the shifter...that was my backup plan
Thread
Thread Starter
Forum
Replies
Last Post
stockssn2o
Parts For Sale
14
May 25, 2015 08:54 AM
Rich_z28
Car Audio and Electronics
3
Aug 29, 2002 10:44 PM