Just got done with my heads and cam swap (TSP 5.3L 2.5 stage, TSP V3 cam 231/234 .643"/.598) I'm still fine tuning a few things, it runs pretty good overall, my oil pressure sending unit is leaking that's going to be a pain in the ***. I'm not going to drive the car until i install the new torque converter (yank 3600) and i'm also waiting for my Y pipe. Here's how it sounds as of now, it needs a tune pretty bad.

http://www.youtube.com/watch?v=qJ45JDmCLoE

 

Sounds good. Its going to be almost the same setup like mine. Im returning those heads and I already ordered the 5.3s texas-speed heads. All I have to figure out is how im going return those crap 241s to that a-hole.. Hes making it real difficult. BTW your camaro looks just like mine lol...besides the blacked out tail lights and camaro in black.... I also have the c5 wheels. Theyre much lighter then my old z06 wheels

 

Yeah I love my Yank ss3600. Pretty easy install. Pain in the *** doing it in my drive way tho lol

 

Sounds good but with that much cam you'd be better off with an SS4000. With the 3600 when you launch it'll fall flat for just a little bit then start pulling hard. With a 4000 it'll start right out pulling hard. Of course it's going to take a tire and some suspension pieces to make it hook.

 

man that sounds bad a@@ goodjob

 

Start up videos are always good, sounds great. I do not recall ever seeing an engine with that much more intake lift than exhaust.

 

Get that sonofabitch together and go driving!

 

I've had a pretty tight schedule, next weekend i should be getting my tune if nothing else comes up. I've been driving it around like a granny lately, i got on it a couple of times and it's a monster even without a tune! I'll update this thread with some new videos hopefully next week