JUst got it!!, i hope it works fine
I just got my Richmond 3.73 gears today and I am so anxious to put them in this week. (just waiting to buy hpp3 cheap somewhere)
I heard those gears whine a little bit, but that doesnt bother me, what about performace increase, will i feel it?
thanks
S.P.
1.78/12.789@106.9
With gears/sfc,lca hope for 1.6/12.3/4@108mph *what do you think*
I heard those gears whine a little bit, but that doesnt bother me, what about performace increase, will i feel it?
thanks
S.P.
1.78/12.789@106.9
With gears/sfc,lca hope for 1.6/12.3/4@108mph *what do you think*
What the gear gods giveth, the gear gods taketh.
All things being equal you'll pick up about .05 to .1 and about 1.5 mhp at the top end. You'll lose about 1 mph on the short half of the track and you'll get about an extra .03 on your 60s.
Been there, done that. What you're going to see is that you will consistantly run around what your best time has been and the spread on your 60s will be a lot tighter.
------------------
'01 Mystic Teal Z28
A4/3.23/Leather/T-Tops
Mods List Here
12.46/108.87/1.75 60'
319 rwhp/349 rwtq
www.MysticZ28.com
NorCal LS1/LT1
"To play it safe is not to play"
All things being equal you'll pick up about .05 to .1 and about 1.5 mhp at the top end. You'll lose about 1 mph on the short half of the track and you'll get about an extra .03 on your 60s.
Been there, done that. What you're going to see is that you will consistantly run around what your best time has been and the spread on your 60s will be a lot tighter.
------------------
'01 Mystic Teal Z28
A4/3.23/Leather/T-Tops
Mods List Here
12.46/108.87/1.75 60'
319 rwhp/349 rwtq
www.MysticZ28.com
NorCal LS1/LT1
"To play it safe is not to play"
my budy gained .3 tenths though...that is what i hope for...anyone else with opinion...thanks
also, richmond 3.73 are they good gears?.
let me know what u think.
(soon as it is installed, I will run it and let you know the gain, (it is kind of hot and humid now in florida but i will let you guys know how i do)...
anyone else opinion..
also, richmond 3.73 are they good gears?.
let me know what u think.
(soon as it is installed, I will run it and let you know the gain, (it is kind of hot and humid now in florida but i will let you guys know how i do)...
anyone else opinion..
I have 4.10s in my car....and wholy crap did it wake the car up. I'm not sure about times yet, as I haven't been - but the seat of the pants feeling is wayyyyyyyyy up there.
But when you get that extream, get ready to do your suspension to hook up....as that is what I am doing now. I just installed everything in my sig as of today. The car is at the shop getting the sub-frame connectors welded on. Now, sub frame connectors won't help help you hook up by themsleves, but they do play an important role in your overall suspension set up.
I think you'll like the gears....btw, when I got my gears, I had to buy a HPP to adjust them.....but the local GM dealers around here said that they could have programmed my car if it had 3.73s. I'd call around and see if you can just get the programming done. I couldn't hurt.
Milo.
------------------
'98 Camaro Z28
-MODS:
But when you get that extream, get ready to do your suspension to hook up....as that is what I am doing now. I just installed everything in my sig as of today. The car is at the shop getting the sub-frame connectors welded on. Now, sub frame connectors won't help help you hook up by themsleves, but they do play an important role in your overall suspension set up.
I think you'll like the gears....btw, when I got my gears, I had to buy a HPP to adjust them.....but the local GM dealers around here said that they could have programmed my car if it had 3.73s. I'd call around and see if you can just get the programming done. I couldn't hurt.
Milo.
------------------
'98 Camaro Z28
-MODS:
- Auto
- 4.10 Gears
- HPP +
- 180* Thermostat
- FTRA
- Whisper Lid
- K&N Filter
- MSD 8MM Wires
- NGK55 Plugs
- MAC Panhard Rod (red)
- MAC Lower Control Arms (red)
- T Byrne Sub-Frame Connectors (red)
- Eibach Lowering Springs (red)
- KYB AGX 5 Way Adj. Shocks (red)
- BMR Relocation Brackets (red)
- BMR Strut Tower Brace (red)
- ! Air conditioning
- ! Cruise Control
- ! CAT
- ! Front Steel Bumper
- '98 SS Single outlet Exhaust
- Clear Turn Signals
oh yeah, afcourse.
I am getting SFC (stiffend the body) and LCA( to help me with the hooking up and not spining -power to the ground).
Hpp3 is what I will probably get to adjust my gears.
we shall see how is going to feel, i hope that i like it...I really dont want to spend 500$ and gain nothing.
Sasa
I am getting SFC (stiffend the body) and LCA( to help me with the hooking up and not spining -power to the ground).
Hpp3 is what I will probably get to adjust my gears.
we shall see how is going to feel, i hope that i like it...I really dont want to spend 500$ and gain nothing.
Sasa
Look at www.thunderracing.com, they sell a speedometer recalibrator from SLP for 150, have never used it or seen it, but its better than 350 for the hpp3, especially if you have an M6.
------------------
'02 Red Z28, ebony leather, M6, T-tops, Trac. cont., hurst shifter
-Borla (the expensive cut-out)
-Wisperlid W/K&N
-FRA
-Cags eliminator
-Strange 4.10's
-G2 Rear Girdle
-Valv. Synthetic 10W-30
-Redline gear oil
-Fat hurst shift ****
-Lead foot
Soon to be:
Alpine Screen, Orion xtr 800.4, xtr 900.2, Kicker 12L7 in a milhouse, Focal polykev K2's.
------------------
'02 Red Z28, ebony leather, M6, T-tops, Trac. cont., hurst shifter
-Borla (the expensive cut-out)
-Wisperlid W/K&N
-FRA
-Cags eliminator
-Strange 4.10's
-G2 Rear Girdle
-Valv. Synthetic 10W-30
-Redline gear oil
-Fat hurst shift ****
-Lead foot
Soon to be:
Alpine Screen, Orion xtr 800.4, xtr 900.2, Kicker 12L7 in a milhouse, Focal polykev K2's.
I tried the SLP speedo calibrator before I bought the HPP3, and it caused problems for me. It was inexact in the speedo correction, and it caused my cruise control to non-functional about 80% of the time. Removed it, and everything worked fine again. Very strange.
Hot Pastrami!
------------------
Onyx Black 2000 SS M6
!CAGS
Flowmaster
Direct-Flo Lid
4.10 gears
Z06 clutch
Hypertech Power Programmer
NEXT: Cutout, Ported MAF
Hot Pastrami!
------------------
Onyx Black 2000 SS M6
!CAGS
Flowmaster
Direct-Flo Lid
4.10 gears
Z06 clutch
Hypertech Power Programmer
NEXT: Cutout, Ported MAF
oh, I will try to buy used 98hpp3, but i need one asap. gears are just waiting for hpp3 to arrive and the car is ready to be operated. I got A4 so I will get hpp3 for the rest of the options( speed limiter, adjusting shift points.etc...)
so, I am spending about $500 on this gears swap, it better be worth it..I read many good gains about it, i hope that happens to me as well. i am going from 2.73 to 3.73 and I also got 3500stall TC..
i can't wait to have it done though!
S.P
[This message has been edited by U2Slow (edited June 14, 2002).]
so, I am spending about $500 on this gears swap, it better be worth it..I read many good gains about it, i hope that happens to me as well. i am going from 2.73 to 3.73 and I also got 3500stall TC..
i can't wait to have it done though!
S.P
[This message has been edited by U2Slow (edited June 14, 2002).]
Thread
Thread Starter
Forum
Replies
Last Post
Rino1313
Car Audio and Electronics
2
Jul 18, 2002 05:16 PM



