I just got this put on today, I took the really cheap way out, it doesn't look the greatest but it gets the job done. Instead of splitting the pipe after the rearend, I just put a single 3 inch pipe out the passenger side. It sounds pretty good (my daughter says "it sounds like a muffled fart pipe", I'm gonna smack her!) I think I lost some low end, but it definetly rocks in the higher rpm range. I don't remember who originally posted the info on doing this , but thanks. I had been thinking about it for some time, before I ever saw it in here, but was afraid to go hacking on a stainless system, but when I saw other people doing it with good results I said what the heck!! BTW fully installed parts and labor was only $110.00, thats a helluva lot cheaper than any mass produced cat back. Thanks again!!
Ottis

------------------
2001 Pontiac Trans Am WS-6 #2832
Automatic, 3.23 gears bright red
Mods
LS1 motorsports lid, SLPMAF 85mm, BBK 80mm Throttlebody, SLP intake air temp module, Holley power shot filter, and Throttle Body coolant bypass.
Best et 13.131 @ 105.61 w/ a 1.995 60 ft on stock tires.
Best ET 13.6@102.19 Bone Stock
Maintaned cobra tag on it
Va. "Z20 WUT"

 

Hey, congrats!
Gotta love that sound.
If you get a sound clip I'd like to hear a Dynomouth set up like that.
Dave

------------------

• Dynomouth Exhaust!
• My 98...318 rwhp/334 ft lbs
• Mesh Grille
• 71-74 Emblems
• Clear Corners
• My New Home Page
• mn55927@citlink.net