when i did it we took about 1/4 to about half of the tb bump stop....


is that normal????

how much does this help???

 

You probably won't notice any difference...I didn't. Just make sure your TPS volts are not over 2.6volts.

 

how do i check that......

could that mod screw it up????

 

I thought that was 4.6 volts?

Anyway you're supposed to measure (by using a voltmeter) by checking the voltage level at the TPS connector (I think it was the blue wire). Don't know about damage but an SES light.

 

so what your saying is that ill get an ses light

 

As per Install University:
http://www.installuniversity.com/ins..._bump_stop.htm

 

@#!% i hope mines not over 90 degrees

 

I just measured my TB. It came out to 4.28. Is it worth getting up to 4.65? What will that do for me? Thanks

 

I don't know, that still makes you almost 8% off.