Who has made a Vortech power pipe (solid intake tube) with PVC tubing???
Registered User
Joined: Mar 2002
Posts: 3,082
From: San Juan PR
I did...
What I did was this: I bought 2 90* elbows from a truck parts store and I soldered them together... I then used the rubber "connectors" and then I used a 90* 3.5" PVC elbow with a male end and a female end on the other side... Later I used a tube and drilled necessary holes... I used PVC glue (very important) and it has been working fine since!!!
Total cost??? ~80 since the 90* elbows where $28 each. I will probably change to metal later on, but so far so good.
What I did was this: I bought 2 90* elbows from a truck parts store and I soldered them together... I then used the rubber "connectors" and then I used a 90* 3.5" PVC elbow with a male end and a female end on the other side... Later I used a tube and drilled necessary holes... I used PVC glue (very important) and it has been working fine since!!!
Total cost??? ~80 since the 90* elbows where $28 each. I will probably change to metal later on, but so far so good.
Thread Starter
Registered User
Joined: Feb 2001
Posts: 1,967
From: Bay Area, CA, USA
Okay... I was thinking that the whole thing could be made from PCV... how do you seal it properly??? PCV glue, RTV, teflon tape? I need more info =)
It's basically just putting together the right combination of bends right?
It's basically just putting together the right combination of bends right?
Registered User
Joined: Dec 2002
Posts: 134
From: Roy, Utah
Originally posted by RCF925
I made one with PVC and a couple of rubber boots at both ends. Gained 1 lb of boost and it was only about $15.00
I made one with PVC and a couple of rubber boots at both ends. Gained 1 lb of boost and it was only about $15.00
Thread
Thread Starter
Forum
Replies
Last Post
