I edited a program for a 2 bar, and now something is not right the car will start and die about 10 seconds later. Any ideas?

 

you must not have edited it right does it work in speed density mode?

 

no it doesn't work at all SD or MAF

 

why dont you put it back to a 1 bar program and see if itll run

 

That's what I was going to suggest also. If it doesn't run, then maybe you accidentally changed something else in the program that is causing it to cut off.

Does it smell like it is loading up on fuel and then stalling? Or is it running normally and then just cutting off abruptly?

 

it only runs about 10 seconds with the 2 bar program and then the injector pulse width goes to 0 and dies. runs fine with the 1 bar other than the other problem i can't figure out see other post.