Drivetrain Clutch, Torque Converter, Transmission, Driveline, Axles, Rear Ends

transmssion problem????????

Thread Tools
 
Search this Thread
 
Old Jan 9, 2008 | 05:16 PM
  #1  
95camarodude's Avatar
Thread Starter
Registered User
 
Joined: Dec 2007
Posts: 54
transmssion problem????????

Ok first off i was just driving and it did this. i was going to the gas station and i felt like a "clunk" (not to loud but not to quite) and next thing you know i can't shift into any gear. i finally got it to shift and drive far enough to pull into the gas station (about 100 ft coasted most of the way) but after that it wouldnt move in any gear. it will run but acts as if the clutch is engaged and wants to kill itself. softly it doesnt like jurk the car forward or nothin just idles for a couple of seceonds and kills itself. Motor is a fresh rebuild. and motor sounds fine when in neautral with the clutch engaged. it has to be something n the tranny or clutch assembly somewhere. Just replaced clutch with spec stage two+ and ran fine fr a while. this came out of nowhere. Any input, suggestions, or ideas would be great. thanks guys.
Old Jan 9, 2008 | 07:47 PM
  #2  
95camarodude's Avatar
Thread Starter
Registered User
 
Joined: Dec 2007
Posts: 54
nobody has any ideas at all. come on i need an idea of what it could be. this hasnthappened to anyone before?
Old Jan 9, 2008 | 07:56 PM
  #3  
greenmachinedriver's Avatar
Registered User
 
Joined: Oct 2007
Posts: 387
From: dallas tx
if i am reading this right your symptoms are that it is hard to get in gear and id dieas at idle when in gear. sounds like the clutch is not disengaging check the hydraulics. also the check the fork ti may have come off its pivot.

this probably does not belong in the lt section the drivetrain section would probably be more appropriate
Old Jan 9, 2008 | 07:58 PM
  #4  
Javier97Z28's Avatar
Moderator
 
Joined: Dec 1999
Posts: 3,853
From: Jupiter (NPB), Fl
I'll move this to the drivetrain forum where our transmission sponsors can more properly assist you..
Old Jan 10, 2008 | 05:27 AM
  #5  
'94 Bad A Z28's Avatar
Registered User
 
Joined: Jan 2001
Posts: 2,905
From: Orlando,Fl
Your description of what it is doing is kind of vague. But to me it sounds like a broken ring and pinion.
Old Jan 12, 2008 | 09:02 PM
  #6  
95camarodude's Avatar
Thread Starter
Registered User
 
Joined: Dec 2007
Posts: 54
it made a quite thunk and i had no gears. as in i couldnt shift into a gear. i finally got in 2nd but i had to shove it into gear. i pulled into the gas station and it felt like something in transmisson was binding. as in it would rotate but it felt like something was in the was. i put in reverse and it locked up the wheels so then i put it in neutral and pushed it into the parking spot. I really need some help with this situation, thanks for the so far also guys. you guys are awsome.
Old Jan 13, 2008 | 05:39 AM
  #7  
'94 Bad A Z28's Avatar
Registered User
 
Joined: Jan 2001
Posts: 2,905
From: Orlando,Fl
Well you got me on that one then. I couldn't even tell you where to begin with that.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
liamcg97
LT1 Based Engine Tech
17
Nov 25, 2019 05:55 PM
Matt W
LT1 Based Engine Tech
6
Apr 24, 2015 12:54 AM
AlaskaZ28
LT1 Based Engine Tech
12
Apr 17, 2015 08:54 AM
greenzee28
Fuel and Ignition
7
Mar 26, 2015 09:13 AM
Magenta_Hearts
New Member Introduction
4
Mar 25, 2015 10:24 AM




All times are GMT -5. The time now is 06:33 AM.