Narrowing a 9in
#1
Narrowing a 9in
I started to place my order today for a Moser 9in rear but I'm stuck trying to make one decision. How much to narrow? I've had several people say narrowing 2 inches will allow a 28in tire to sit inside the fender. Would anyone know if this is 2in on each side or 2in end-to-end? Would I want to go to 2.5in?
Take a look at THESE pics of my car and you can see that my wheels (15x10 Centerline Telstars) already stick out about 1-1.5in with the stock width. I've already had trouble with the edge of the fender cutting my tires up so I'd like the width to be corrected on the 9in. I believe the wheels have a 5in backspacing.
Take a look at THESE pics of my car and you can see that my wheels (15x10 Centerline Telstars) already stick out about 1-1.5in with the stock width. I've already had trouble with the edge of the fender cutting my tires up so I'd like the width to be corrected on the 9in. I believe the wheels have a 5in backspacing.
#2
Re: Narrowing a 9in
Took the car to Frank @ BMR and let them make the call. We're going 1in on each side.
Never can say enough good things about those guys. Frank spent a good half an hour just looking and measuring to be sure I would be happy with how the new 9in sits under the car. Next week I'll be installing and posting pics.
Never can say enough good things about those guys. Frank spent a good half an hour just looking and measuring to be sure I would be happy with how the new 9in sits under the car. Next week I'll be installing and posting pics.
Thread
Thread Starter
Forum
Replies
Last Post
KillerTA
Wheels and Tires
5
05-31-2015 12:20 PM