I am about to buy a built T56 to do a A4 to M6 swap in my Z

my question is.

Pcm retuned
new master cylinder
new slave cylinder
pedal set

What else will i need besides the for-mentioned

will i need a new wiring harness for a m6?? or does the A4 have a manual provision for it?

also what else will i need to do everything??? is the drive shaft a different length??.....etc.etc.

thanks guy, Scott

 

Im pretty sure you shouldn't need a diff wiring harness since the computer doesnt control the shifts.

 

http://www.afrashteh.com/tranny_pics/T56.htm

You will need a 6spd program for the PCM. I see you have pcmforless tuning. I'm sure they can do it. I did mine with tunercat.

If you are not getting a complete swap kit you will need.
Crossmember
Torque arm mounts
Pigtails for vss, reverse lights, reverse lock out and the clutch switch on the pedals.
Rubber boot that attaches to trans tunnel.
6spd insert for console.
U bolt for clutch master cylinder.

Probably some other stuff I haven't thought of.