After swapping to an OBDI conversion computer....
Thread Starter
Registered User
Joined: Jul 2001
Posts: 1,009
From: so close I can taste it...
After swapping to an OBDI conversion computer....
has anyone noticed that they can't run as much timing @ WOT?
I logged a couple of runs w/ Autotap before I swapped to my OBDI conversion and if I remember right I could run about 36-38 degrees and no knock.
Now after converting to an OBDI pcm setup to use the OBDII knock sensor, I can only run 33-34 degrees.
Not sure if it makes a difference hp wise, but seems odd anyways.
Anyone else had a similiar situation using the OBDI ks with the conversion computer?
I logged a couple of runs w/ Autotap before I swapped to my OBDI conversion and if I remember right I could run about 36-38 degrees and no knock.
Now after converting to an OBDI pcm setup to use the OBDII knock sensor, I can only run 33-34 degrees.
Not sure if it makes a difference hp wise, but seems odd anyways.
Anyone else had a similiar situation using the OBDI ks with the conversion computer?
Thread
Thread Starter
Forum
Replies
Last Post
gonzo275rltw
3rd Gen / L98 Engine Tech
4
Sep 7, 2015 04:46 PM
gonzo275rltw
LT1 Based Engine Tech
4
Sep 5, 2015 06:26 PM
gonzo275rltw
LS1 Based Engine Tech
2
Sep 5, 2015 06:24 PM