Is a new air dam needed for an F-1 body kit
#1
Is a new air dam needed for an F-1 body kit
Just like the subject says. Is a new air dam needed with the Front F-1 piece. It has a lot of holes and isnt very low to the ground. The few websites I have seen it on dont say anything about it in the kit or in the single just the front piece. The front is the only part I want, and theres no option below for the air dam. I dont know if its included in the cut and just not for separate retail or what.
------------------
http://www.sounddomain.com/id/jeff94z28
Borla Exhuast, K&N filter, Jamex Strut bar, 160 stat, Hedmen High flow Cat, BMR Lowering Springs, Painted A/C vents/Fake Scoops, 2 12inch MTX subs, Rear Fill in Lettering.
------------------
http://www.sounddomain.com/id/jeff94z28
Borla Exhuast, K&N filter, Jamex Strut bar, 160 stat, Hedmen High flow Cat, BMR Lowering Springs, Painted A/C vents/Fake Scoops, 2 12inch MTX subs, Rear Fill in Lettering.
#5
im not sure about that body kit and i got the wings west body kit and i had to purcahse one from them....
goto there website: www.wingswest.com
hope that helps...
goto there website: www.wingswest.com
hope that helps...
Thread
Thread Starter
Forum
Replies
Last Post
CARiD
Supporting Vendor Group Purchases and Sales
0
12-26-2014 04:20 AM
chevroletfreak
LT1 Based Engine Tech
202
07-04-2005 05:00 PM
ezcheeze15
Car Audio and Electronics
0
08-08-2002 12:27 AM