Help aligning new SS emblems on fenders
Thread Starter
Registered User
Joined: Dec 1969
Posts: 147
From: Chesnee, SC
Help aligning new SS emblems on fenders
Brent I think posted once the measurements, can you again please. I want to make sure I get them back on straight and were they are suppose to go after new paint job.
Viper
Viper
Super Moderator
Joined: May 1999
Posts: 4,060
From: Inverness, FL
Since I don't have car to go measure from, I did a search and found where I answered this last time. Here you go!
-----
Here is a picture...
http://www.bfranker.badz28.com/fbody/cal186.JPG
Spacing is 3.5" and 1.5"
3.5" from the edge of the fender to the bottom (wider portion) of the first "S" and 1.5" from the center of the fender horizontal indentation (I don't have door edge mouldings) to the bottom of the "SS" letters.
------------------
Brent Franker * Main Page
94 Vortech Z28 * 96 Z28 SS #1655
4th Gen Appearance Modification Guide
F-Body Install & Fix-It Guides
-----
Here is a picture...
http://www.bfranker.badz28.com/fbody/cal186.JPG
Spacing is 3.5" and 1.5"
3.5" from the edge of the fender to the bottom (wider portion) of the first "S" and 1.5" from the center of the fender horizontal indentation (I don't have door edge mouldings) to the bottom of the "SS" letters.
------------------
Brent Franker * Main Page
94 Vortech Z28 * 96 Z28 SS #1655
4th Gen Appearance Modification Guide
F-Body Install & Fix-It Guides
Thread
Thread Starter
Forum
Replies
Last Post
ducttape1975
New Member Introduction
2
Jul 10, 2015 06:29 PM