well motor is almost torn down but i haven't taken these splayed caps off and was wondering if someone could assist on this progress. sooner i get it stripped the sooner the block gets cryo'ed. etc.....

tia!!!
taner

 

take out the studs, then tap them with a plastic or rubber hammer on the side untill they dis lodge.

No comment on the block cryo.

Bret

 

thanks SStrokerace,i figured as much but didn't want to mess with it until it was confirmed! no coment required on the block cryo

 

I assume you are going to reinstall the caps after the engine is disassembled so you can have them cryo'd too, right?

 

timberwolf,

i am freezing almost everything rods, block, cam, valve springs, valves, pistons, rings, bearings, etc....