Ok guys,

I am looking for direct replacement radiator that will cool 600+HP. My biggest problem is Im very limited on depth because my blower pulley is VERY close to the upper radiator as it is. Any ideas??

 

BeCool makes a bolt-in replacement that should be adequate, although I'd call them to verify that it'll handle the heat before I ordered it. If it's not enough, you can yank the A/C condensor and gain an extra inch in the front for a thicker core.

 

Car currently has no ac so that should make it a little easier. Also, I have seen summit advertise a generic alum radiator. Has anyone tried one of these in our 3rd gens. Also, what about relocating the upper rad hose for more blower clearance. Thanks!

 

im in the same boat . the one in summit is 500$

 

Do a search over on www.thirdgen.org Someone will a setup similar to yours (in power output) installed a much more cost friendly Griffin universal into his car. It required some fabrication, but he claimed the results were worth it.