Ok Im finally getting my engine back today. Now when i was pulling off my headers when i was removing the engine, it was a tight squeeze. Can i bolt the headers to the engine and then drop it in? or will I not be able to squeeze the drivers side header past the power steering?

 

not sure what headers your using. but from my experiances, ive had to always put the driver side header on from under the car. plenty of room on the passenger side

 

Ive got hedman shorties. so what did u do...sorry i dont understand what u mean by ur last post lol

 

i dropped my engine in with both driver and passenger side Hooker 2055s on it. It was pretty tight, but I got it in. Donno about the Hedmans.

 

I have the Hedman shorties, and I put those in after I had the engine in. I did it that way because the whole engine bay was ripped apart, so why not Took me about an hour to get them in and bolted.

 

ok ill try this again. for me, from up top i was able to drop my passenger side on. but on the driver side i had to move the header on from under the car.
i couldnt just drop it in from the top.
make a little more sense now?

 

yea now i get it lol, sorry, alittle tired over here...cars driving me nuts

 

I have Edelbrock TES headers for my 400, and I installed both of them from up top after I dropped the motor in the car.

- Justin