ok i got my motor dropped in and basically ready to go...
are there any of you guys thats done an LT1 swap and reused there GEN 1 brackets?...
the 2 bolts on the bottom and 1 on the head line up perfectly..but when i put the water pump on i can get the 2 on the bottom to line up...
i was thinking about cutting a notch in the brakect to "slide" over the water pump..has anyone done this?..

how much are LT1 brackets?...id have to get them new because there arent any junk yards around here with 4th gens..or LT1 cars for that matter

thanks guys!!
Rob

 

I am not sure how much they are new, but I have an extra one that I'd sell for $45 + shipping. It is slightly polished on the top corner, haven't had time to finish polishing it.

 

manny..this is rob (f-crazy) from TGO...how goes it lol

is that bracket for the passenger or driver side?...

i still have my a/c crap there but i dont know if im gonna use it yet...the only ones that i really need is the ALT> and power steering...

btw did youy get a chance to to send out that water pump coupler...i need your addres so i can send you a "few" dollars for it..i know u said dont worry about it but...i dont care lol...

thanks again

Rob

 

Hey Rob,
Didn't send out the coupler yet, still looking for one of them, I've got 2 somewhere in my garage,

I'll be cleaning up the garage tomorrow so I can organize all of my parts and bolts so that they don't get misplaced again.

This is my address,
Manuel Desantos
1723 Kingston Ave
Norfolk, VA 23503

That bracket is for the pass side.

Manny