P600b ?

I bought a P600b with twin high flow intercoolers off some on this site a while back.I read the instructions on shiming or spacing the fan motors.I didnt find any spacers in the box.Nor do I have a visual guide to help me out.Are they just washers or cylinder type spacers. Any help would be apprciated.

There should be some small silver cylinder type spacers, two different thicknesses as one of the fans they make at a different depth.

Its been a while but one was appox 3/8 and the other was about a half inch, just put the fans in the shroud and check for clearance between the edge of the fan and the radiator, the spacers just push the fans closer to the radiator, you can fab up something that should work.

Marc

When I bought my P600 used that is about the only thing it didn't come with. I just stacked a few washers between the fan motor and housing with some longer screws and worked fine.

Thats what I was thinking I was going to do.I just wasnt sure if it was special piece or something.So Ill just put some washers in unless I can find something at the Depot.

are you the person i sold my kit too if you are i have the shims for it i just looked why didnt you email me i would of sent them i completely forgot about them they are chillin in my tool box. sorry about that :( but im sure i can put them in the mail pretty easy if you need them still

my email has been messed up lately so if you sent me any emails i might not of gotten them.

How is the kit install going isnt it a pain in the ass lol :D I was going to pull my hair out the first time i put that bastard on there lol

steve

Yea I sent you a email but I fiigured you where out or busy or something.You usually write me back right away.Anyway its almost done and yes its been a pain in the arse but a learning expierence at the same time.If you can Steve shoot me an email or PM on this site if I can give a call.I still have a few questions to make sure Im doing it right.