installing 160 stat

Reply Subscribe

Thread Tools

Search this Thread

Jun 5, 2003 | 01:29 AM

PaulN64

Thread Starter

Registered User

Joined: Feb 2001

Posts: 1,288

From: Macon,GA, USA

installing 160 stat

ok, just got my Hypertech 160 stat tonight and going to install it tomorrow. Just wondering if there's anything special I should watch out for. Thanks

Jun 5, 2003 | 01:53 AM

frmula1

Registered User

Joined: Nov 2002

Posts: 1,201

From: Somewhere between a shotgun barrel, and a blood spatter on the wall.

anything to watch out for???

umm ...nope?

just make sure you get all that air outta the lines before you seal it all up when your done...

Jun 5, 2003 | 05:09 AM

Hyperspeed97z28

Registered User

Joined: Dec 2001

Posts: 3,615

From: Upstate, NY (Albany area)

gonna need some rags so ur opti dont get wet, its only 2 bolts after you remove your intake elbow and maf, i think its 2 10mm bolts...

Jun 5, 2003 | 08:34 AM

shoebox

Registered User

Joined: Dec 1969

Posts: 27,730

From: Little Rock, AR

Easy thermostat change out

Jun 5, 2003 | 10:51 AM

PaulN64

Thread Starter

Registered User

Joined: Feb 2001

Posts: 1,288

From: Macon,GA, USA

thanks for all the help....
160 stat install 101...need lots of towels!

Even the car sitting over night, that was lots of coolant. Also, put towels in the TB and MAF.

Took it for a test drive and seems to work fine. No leaks, knock on wood. Thanks again