CamaroZ28.Com Message Board
August 2008, The "find" 500.00 1996 Z28 Six speed 141k miles under an Oak tree... Note: Skeeter lagoon in the car...windows partly down for a year...
August 2008, The "find" 500.00 1996 Z28 Six speed 141k miles under an Oak tree... Note: Skeeter lagoon in the car...windows partly down for a year...
0 2009/12/18 15:28:56
Splish Splash...Skeeter lagoon!!!!
Splish Splash...Skeeter lagoon!!!!
0 2009/12/18 15:39:54
Note the trash bag window, No it did't work,see the skeeter lagoon!
Note the trash bag window, No it did't work,see the skeeter lagoon!
0 2009/12/18 15:39:54
After setting for a year, put in a battery and it started up!!!Oak leaves anyone?
After setting for a year, put in a battery and it started up!!!Oak leaves anyone?
0 2009/12/18 15:46:16
The leather seats were "ToasT'
The leather seats were "ToasT'
0 2009/12/18 15:46:16
Yes over a year with the window down, and the floor boards just have surface rust!!! Yes I found 11.35 in change
Yes over a year with the window down, and the floor boards just have surface rust!!! Yes I found 11.35 in change
0 2009/12/18 15:46:16
With the engine sold, I preped the towers, sprayed with urethane primer, painted base coat GM white, blue pearl, next, then clear urethane, the pix don't do the color justice in the sun!!!
With the engine sold, I preped the towers, sprayed with urethane primer, painted base coat GM white, blue pearl, next, then clear urethane, the pix don't do the color justice in the sun!!!
0 2009/12/18 15:54:06
GM 8.5 diff 7 inches shorter than OE, Note the torque arm mount, this diff was built by Performace Clinic for Dik Griffin's 10 sec. 82 Firebird back in 1983, 3:73 gears 28 spline BOP axles (No "C" clips) The 96 FB disc brakes bolted right on the axle tubes!!!
GM 8.5 diff 7 inches shorter than OE, Note the torque arm mount, this diff was built by Performace Clinic for Dik Griffin's 10 sec. 82 Firebird back in 1983, 3:73 gears 28 spline BOP axles (No "C" clips) The 96 FB disc brakes bolted right on the axle tubes!!!
0 2009/12/18 15:54:06
Scrub, scrub!!! clean, sand, and paint
Scrub, scrub!!! clean, sand, and paint
0 2009/12/18 15:54:06
August 2009: Bob Hess @ Easy Rods in NJ sends me the "Kit" Fins anyone???
August 2009: Bob Hess @ Easy Rods in NJ sends me the "Kit" Fins anyone???
0 2009/12/18 16:13:47
Fit / grind / Glue / and screw
Fit / grind / Glue / and screw
0 2009/12/18 16:13:47
Week two... Ops, Bob sent me a convertible lid, not coupe...
Week two... Ops, Bob sent me a convertible lid, not coupe...
0 2009/12/18 16:18:10
Now fit the doors to the new fenders
Now fit the doors to the new fenders
0 2009/12/18 16:18:10
Adjust / check / Adjust!!!
Adjust / check / Adjust!!!
0 2009/12/18 16:18:10
Grind / adjust / tape / adjust door gap
Grind / adjust / tape / adjust door gap
0 2009/12/18 16:24:00
Grind / adjust / re-tape / adjust door gap / glue / screw
Grind / adjust / re-tape / adjust door gap / glue / screw
0 2009/12/18 16:24:00
yes it's a "mile high" just weight...
yes it's a "mile high" just weight...
0 2009/12/18 16:24:00
Door gap, nice and square
Door gap, nice and square
0 2009/12/18 16:31:40
Hatch lid gap... Well %^&*(&^^&*(
Hatch lid gap... Well %^&*(&^^&*(
0 2009/12/18 16:31:40
Yea, going to have to glass this gap...
Yea, going to have to glass this gap...
0 2009/12/18 16:31:40
Mucho better on the drivers side!
Mucho better on the drivers side!
0 2009/12/18 16:35:14
Drivers door gap, nice and square!
Drivers door gap, nice and square!
0 2009/12/18 16:35:14
ok gap on the front pass fender
ok gap on the front pass fender
0 2009/12/18 16:35:14
rear quarter panel attached to the inner skin
rear quarter panel attached to the inner skin
0 2009/12/18 16:38:56
inner compartment fuel cell / battery / N02 bottles
inner compartment fuel cell / battery / N02 bottles
0 2009/12/18 16:38:56
glass work to fill in gaps
glass work to fill in gaps
0 2009/12/18 16:38:56
Fuel cell compartment
Fuel cell compartment
0 2009/12/18 16:44:05
Trunk lid attached to the camaro rear hatch
Trunk lid attached to the camaro rear hatch
0 2009/12/18 16:44:05
inside of the lid
inside of the lid
0 2009/12/18 16:44:05
The LT4 won't make much vacuum with the mech roller cam, so out goes the ABS, vac booster, in goes Wilwood Master Cly. and adj rear prop valve
The LT4 won't make much vacuum with the mech roller cam, so out goes the ABS, vac booster, in goes Wilwood Master Cly. and adj rear prop valve
0 2009/12/18 16:47:38
Look at those FINS!!!
Look at those FINS!!!
0 2009/12/18 16:47:38
Glass looks strait.. we will find out when it's "blocked"
Glass looks strait.. we will find out when it's "blocked"
0 2009/12/18 16:47:38
Front end comming together
Front end comming together
0 2009/12/18 16:54:29
Yea Baby!!! Love them FINS
Yea Baby!!! Love them FINS
0 2009/12/18 16:54:29
OH Yea, ROCKETS!!!!
OH Yea, ROCKETS!!!!
0 2009/12/18 16:54:29
LTX 6.2 engine
LTX 6.2 engine
0 2010/01/18 14:42:49
LTX 6.2 engine sheet metal intake
LTX 6.2 engine sheet metal intake
0 2010/01/18 14:42:49
LTX 6.2 engine coil near plug LS2 set up
LTX 6.2 engine coil near plug LS2 set up
0 2010/01/18 14:42:49
TIG'ed all bars
TIG'ed all bars
0 2010/05/01 18:15:29
MIG'ed the plated to the floor
MIG'ed the plated to the floor
0 2010/05/01 18:15:29