Local machine shops? (garland/dallas) area.
#4
i can build it...dont it to all my motors...anyone can do the machine work...blaines and city ive both used and both had good success with...just check their work with plasticgauge and if its in speck then go with it...heard about the rod bearing...been there done that
#9
i can build it...dont it to all my motors...anyone can do the machine work...blaines and city ive both used and both had good success with...just check their work with plasticgauge and if its in speck then go with it...heard about the rod bearing...been there done that
Well i found a block with rods crank and pistons so i'm going that route right now. But planning on doing it myself for the experience. Prob need some guidence perhaps.
Btw how is that guy liking those free set of wheels u gave him...
#11
Point being you never should have given him the wheels to begin with or at least call me to verify that he had actually paid me.
Do you even happen to have any info on him? I still wouldn't mind paying him a visit
#13
#15
I used Rick at Metroplex Machine in Mesquite. Lloyd steered me his way. He seemed to do good work and cost wasn't horrible, wasn't cheap either. Haven't put the motor in the car yet, so I don't know the results. Hopefully in two weeks though!
Thread
Thread Starter
Forum
Replies
Last Post