i put my car on the alignment rack and measured my alignment specs only to see a -28 degree thrust angle. my suspension is all stock. no adjustable parts were installed. what could be throwing this off so far? there is a little movement on the right rear wheel front to back if i put on the parking break and push the car front to back but just barely noticable. it doesnt seem like it is enough to be -28 degrees though. any opinions?


thanks.

 

bent panhard bar?
bad bushings?

 

i will have to look at these. is there a difference in length from the third and fourth gen panhard bar. it has junk yard numbers on it so i am assuming its been replaced.

 

i will have to look at these. is there a difference in length from the third and fourth gen panhard bar. it has junk yard numbers on it so i am assuming its been replaced.

 

i will have to look at these. is there a difference in length from the third and fourth gen panhard bar. it has junk yard numbers on it so i am assuming its been replaced.

 

the length is exactly the same, the rear suspensions are exactly the same on third and 4th gens

if that is the case, then u have the perfect excuse to buy an adjustable panhard bar

 

thanks i will have to check it out.