BMR K-Member and Lower A-Arm Fitment?
Thread Starter
Registered User
Joined: May 2001
Posts: 330
From: Altamonte Springs, FL
BMR K-Member and Lower A-Arm Fitment?
I have a 95 Z28 and I went to install and tubular K-Member with my new motor today on a lift and what not and the holes for the k-member in the front didn't fit at all. I had to grind them out for the K-Member to sit flush anyone ever have this issue? Also the washer that is ziptied to the rear that is left in that position correct? I also have tubular lower A-arms for it. The rear part of the arm the silver part I cannot fit the metal sleeves in it. The are way to big for the arms. Any possible way the put the wrong attachment on it? Anyone ever have issues with this.
Thanks A MILLION,
Tyler
Thanks A MILLION,
Tyler
Registered User
Joined: Jun 2002
Posts: 452
From: UCF
Re: BMR K-Member and Lower A-Arm Fitment?
I have searched on the problems we had today and couldn't find a single thing about it. All I know is BMR sent Tyler the wrong A-arm endjoints. I'll post some pics when I get to the shop tomorrow.
Ryan
Ryan
Thread
Thread Starter
Forum
Replies
Last Post
Devinfoote87
General 1967-2002 F-Body Tech
2
Jul 30, 2015 09:54 AM