Got some stuff I want to sell locally:

** Edelbrock 750cfm performer carburetor, $175 obro (paid $230) **
Like new, used for 1 month on weekend basis, have several jet sizes I'll include with it for tuning.

** Moroso electric waterpump for Big Block chevy, $200 obro (paid $240) **
Used to test run my current engine, but wouldn't fit with my pulley arrangment. So it was used really a matter of 1-2 hours max.

** Crane gold 1.6:1 roller rocker arms, wide body, non-self aligning, $150obro (paid $200) **
Used on my LT-1 for around 2500 miles until it spun a bearing. Cannot be used with center bolt valve covers without structurally compromising modification to valve cover

** 14" flywheel for Big Block chevy , $125 obro (paid $180) **
Never used. It's counterweighted for a 2-piece rear seal 454cid. GMPP Part # 3993827

** 12-3/4" flywheel for Big Block Chevy, $125 obro (paid $200) **
Counterweighted for big block 454cid. Engine was started with this flywheel, but the car was never driven. New condition. GMPP # 3963537

** Summit 15 Gallon fuel cell with slosh foam and 90 ohm fuel level sender $125 (paid $170)**
New, never used. Summit # 290108. Wouldn't fit my application.

That's about it for now... would like to sell to someone in central/east central florida to avoid shipping (especially the flywheels)

-Dave C. '97 Z28

 

hey there, i may be interested in the cell, but i wont have the money for a couple weeks.... could you hold it or check with me if someone else asks you about it?

thanks brian
oneqwkfbody@yahoo.com

 

Hey...

If you're planning to put it where your gas tank is now in a 4th gen Camaro, it won't fit. That's why I'm selling it. The axle will hit it if you hit a bump. If you're putting it somewhere else then it should be fine.

-Dave

PS: I'll try to let you know if someone else is interested in it.