LT1 Based Engine Tech 1993-1997 LT1/LT4 Engine Related

lt1 blues

Thread Tools
 
Search this Thread
 
Old Jul 11, 2008 | 07:48 PM
  #1  
markclrks's Avatar
Thread Starter
Registered User
 
Joined: Sep 2007
Posts: 27
lt1 blues

hey guys, got an issue with the 94 lt1... im trying to figure out why the motor shakes like hell. its does it slightly at cold and when warm it goes to shaking enough so i can feel it in the drivers seat, the things iv done are a complete exhaust system, intake gasket, accel dist, new wires new plugs like 3 sets of them, coil, icm, complete egr system, tps, map, i have never had any codes,but it does work. new fuel pump, good pressures, regulartor, the car runs great at wot no miss fire all the way up to 130 i have a scanner still learning what everything means. i know all the electronics are within the book. any i deas would be great
Old Jul 11, 2008 | 07:50 PM
  #2  
Jazsun's Avatar
Registered User
 
Joined: Jun 2005
Posts: 1,834
From: Indiana
could be an idle air sensor or MAF issue if its just a non WOT problem. Try unplugging the MAF and running the car.
Old Jul 11, 2008 | 08:02 PM
  #3  
markclrks's Avatar
Thread Starter
Registered User
 
Joined: Sep 2007
Posts: 27
yeah i tried that just kills the car, i know all the electronics work fine the numbers on all of them are the same as the book
Old Jul 11, 2008 | 08:03 PM
  #4  
markclrks's Avatar
Thread Starter
Registered User
 
Joined: Sep 2007
Posts: 27
i also had pcm for less reprogramed the computer a month ago
Old Jul 11, 2008 | 09:10 PM
  #5  
markclrks's Avatar
Thread Starter
Registered User
 
Joined: Sep 2007
Posts: 27
update

got an up date finaly got dark out and i see every dame spark plug arching at cylinder head, what would cause that its not glowing already went thou that with msd today, i grounded the heads to the bat and still the same the wires are 1 month old the opti was replaced a month and half ago i took the new coil off my drag truck and still same thing, has anyone run in to this
Old Jul 12, 2008 | 11:14 AM
  #6  
camaro1fastz28's Avatar
Registered User
 
Joined: Jan 2006
Posts: 251
yea the wire are bad or not fully on
Old Jul 12, 2008 | 01:25 PM
  #7  
markclrks's Avatar
Thread Starter
Registered User
 
Joined: Sep 2007
Posts: 27
yeah i checked that too they all snaped on with no prob. so far i used the taylor wires had probs then went back to ac delco there boots are shorter than taylors thou, im about ready to yank out all my msd stuff i just put a set of auto lights 104 back in msd told me to they say the platnuims foul out there right i tried ac oem boch, ngk ur and they all went bad after 2000 miles, i did have somthing weired happen on the scanner today it tried to go into open loop while driving intown. no probs on interstate fuel trim at 128L and 129R longterm dont know what to do been to many auto shops and no one can figure it out.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
DirtyDaveW
Forced Induction
13
Dec 1, 2016 05:37 PM
Feffman
Autocross and Road Racing Technique
4
Oct 9, 2015 05:42 AM
PFYC
Supporting Vendor Group Purchases and Sales
0
Jan 23, 2015 01:13 PM
PFYC
Supporting Vendor Group Purchases and Sales
0
Dec 4, 2014 11:56 AM
99TransAmWS6
Midwest
5
Jul 26, 2002 03:18 PM




All times are GMT -5. The time now is 11:45 AM.