finnally got my long tubes installed after struggling to put them in from every which way...i lifted the motor from one side at a time..now im concerned that i may have tore the ground wire off of the blockcausing it not to start...im tryining to norrow down the possibilities..any input would be greatly apreciated

 

oh and by the way the car has a new coil, msd wires, and gm distributor installed correctly

 

did you do all that at the same time and it didnt start or did it not start just after the header install

 

Well...check and see if you busted the wire or not?

 

What happens, does the car at least crank, but just won't fire? Seeing that you replaced several components of the ignition system, I would still give it a look over once again.

 

Not trying to steal ur thread but what r the odds i'm having the same problem u r, did the same mods LTheaders, opti, wires, coil, and wont start, but when i unplug the mas air flow, car will start after a few cranks but sounds like im trying to start a high compression motor and dies if i let of the gas, even drove it around the block and drove like s%#t