Tranny wiring (part2)
Thread Starter
Registered User
Joined: May 2003
Posts: 251
Tranny wiring (part2)
Alright so far with my m6-a4 swap I have totally rewired the 13 pin tranny connector from the computer. No problems there.
Now there are 2 connectors on the side of the tranny where the shifter cable routes to on the drivers side from the dash. There was a 4 pin connector, but I traced those wires to a firewall plug that I found on the passenger side. Now there is a 7 pin connector that I am confused about It has a purple wire in it that goes to the starter relay for a ground (so car wont start in anything but park or neutral), a large yellow wire, 2 small light green wires, a pink, a small yellow, and a black. If anyone has a diagram of can look in a factory service manual for a 95 or 96 car with the 4l60e, it would be much appreciated. This is actually on my truck (96 c1500), but it should be the same cause its the tranny from the truck. This is the last thing I need to do before I can finally see what the lt1 can do in my truck
Now there are 2 connectors on the side of the tranny where the shifter cable routes to on the drivers side from the dash. There was a 4 pin connector, but I traced those wires to a firewall plug that I found on the passenger side. Now there is a 7 pin connector that I am confused about It has a purple wire in it that goes to the starter relay for a ground (so car wont start in anything but park or neutral), a large yellow wire, 2 small light green wires, a pink, a small yellow, and a black. If anyone has a diagram of can look in a factory service manual for a 95 or 96 car with the 4l60e, it would be much appreciated. This is actually on my truck (96 c1500), but it should be the same cause its the tranny from the truck. This is the last thing I need to do before I can finally see what the lt1 can do in my truck
Thread
Thread Starter
Forum
Replies
Last Post