Haven't shown off the car in awhile....
Haven't shown off the car in awhile....
Went out for some data logging today since it was nice out. Stopped and grabbed a few pics. Took some video and I am going to try and put together a little video. I am still waiting to go wide open throttle on this thing until I get all the tune ironed out. I threw in the new rear end yesterday and the 3;73 gears made a big difference over the 3:23's. Anyway, here is a teaser and some pics. The videos are some runs @ 3/4 throttle on a dig. camera. Sorry for the bad quality, but just to give you an idea on how the new set up runs. When I get it all dialed in I will do some WOT runs.
***Cliff notes*** New motor and total new set up. Took some pics and a few quick partial throttle runs. ***





Still wainting on my custom intake to get here.....

Click the pics below to watch.....

***Cliff notes*** New motor and total new set up. Took some pics and a few quick partial throttle runs. ***





Still wainting on my custom intake to get here.....

Click the pics below to watch.....

WOW!!! That thing is CLEAN!!!!!! Only thing I would do is lower it a lil,but its pretty perfect the way it is.I really like those zo6 style emblems.How do they look in person?Are you happy with them? I'm really considering getting them.Sharp car guy.
Thanks. Lowering is a no go, it is set up for the track. wheel gap looks are a little smaller than the picture would suggest. It is only about 2 inches. I can fit 3 fingers in between the tire and wheel well. The badges, they are solid Nickel. I really like them. They are hand made in Poland by a really nice guy. Quality is excellent!
Thread
Thread Starter
Forum
Replies
Last Post
PFYC
Supporting Vendor Group Purchases and Sales
0
Dec 4, 2014 11:56 AM




