Body work 101. A writeup on Diy body work
#16
Re: Body work 101. A writeup on Diy body work
im loving this, once your done, im going to print it all out and put it with my other car stuff, im curious though, how can i glass my interior and then paint it all so its nice and smooth and glossy looking, thanks
#17
Re: Body work 101. A writeup on Diy body work
Originally Posted by Snoman73
im loving this, once your done, im going to print it all out and put it with my other car stuff, im curious though, how can i glass my interior and then paint it all so its nice and smooth and glossy looking, thanks
#18
Re: Body work 101. A writeup on Diy body work
Originally Posted by Snoman73
im loving this, once your done, im going to print it all out and put it with my other car stuff, im curious though, how can i glass my interior and then paint it all so its nice and smooth and glossy looking, thanks
When im done Pm me your email addy and ill email you a ms word copy so its easer to print.
Last edited by oneslowz28; 09-12-2006 at 11:54 PM.
#20
Re: Body work 101. A writeup on Diy body work
Congrats!!! This thread has bee chosen for our Thread of the Week for the Episode #56 of our Podcast! http://web.camaross.com/forums/showthread.php?t=475580
#21
Re: Body work 101. A writeup on Diy body work
Originally Posted by ChrisFrez
Congrats!!! This thread has bee chosen for our Thread of the Week for the Episode #56 of our Podcast! http://web.camaross.com/forums/showthread.php?t=475580
#23
Re: Body work 101. A writeup on Diy body work
Im finishing up the next section and should have it up in the next few days.
As for the paint runs check out these from eastwood. http://eastwood.resultspage.com/sear...tom&w=run+file
Im not a painter but i have seen them used to remove runs and then some wet sanding and all is good. I ll rember to out line the procedure in a section of this write up.
As for the paint runs check out these from eastwood. http://eastwood.resultspage.com/sear...tom&w=run+file
Im not a painter but i have seen them used to remove runs and then some wet sanding and all is good. I ll rember to out line the procedure in a section of this write up.
Thread
Thread Starter
Forum
Replies
Last Post
squarehead
General 1967-2002 F-Body Tech
7
01-15-2015 07:02 PM