I recently acquired a 12 bolt rear and the factory torque arm isn't going to cut it. Does anyone out there have a used torque arm lying around and would be able to ship it to 76001. Thanks

95 firebird formula

Ryan

 

I've got a Global West Traclink that I had to take off when I went to a 4" exhaust. For a 93-02 M6 F-Body. I even have an extra rubber bushing set which costs $40 The only difference between mine and a new one would be I cut off a bracket that would hold a custom fit driveshaft loop but I'm pretty sure I still have the bracket so it could be welded back on if you really want it

These are expensive though Cost $559.99
http://www.globalwest.net/camaro93.htm#TRACLINK%20kits

I haven't tried to sell it yet but if you want it for $400 plus shipping, I'll go to the trouble of shipping it for ya

 

Hi,

I have a BMR extreme duty torque arm with a driveshaft safety loop that I'm selling for $325. You do have to have subframe connectors to install it, and because it's been on my car, the crossbrace may or may not fit your car. In the case that it doesn't, it's $70 from BMR.

Let me know if you would like pictures or anything.

Thanks,

Eric

 

Thanks for the replies guys but I'm just looking for the basic tubular torque arm with nothing special on it. Looking for a deal cause I'm kinda low on cash now cause school started again.