I have a Moser 9" with

I'd really like a 9"/31 spline setup or a 12bolt/33 spline setup. I'm open to any kind of carrier. I'll change it to what I want... I'd like to go posi, but I can't with this setup because there's no posi unit available for 35 spline 9".

I would also like it best within driving distance of St. Louis, MO. I'll drive up to about 6 hours in any direction to make the swap. Also note that this rear end is all good stuff. I won't trade for junk.

 

Interested in selling it outright?

 

No. There would be a big hole under my car.

 

Haha, that would not be good. I just thought I'd ask. Good luck with your quest. Keep me in mind if you should reconsider.

 

Jared, i have a Moser 12 bolt 31 spline axles, 4.10's, HD Eaton, Aluminum cover, billet 1350 yoke, LS1 brakes.. calipers have been ground on too clear my wheels but they still work just fine
i also have new ARP 12mm 2.5" wheel studs that arent put in it yet
not sure if my driveshaft will work with a 9" tho..Denny's nitrous ready steel shaft

get back too me on FAST..."blackchevy" we might be able too work something out...

 

cool. dropping you a PM on FAST...

 

I'll consider a trade, but I'm in PA and we'd have to figure out shipping. LTL freight is probably about $120. I'll check. My 12 bolt is an essentialy new DTS 12 bolt 33 spline, Eaton Posi, Fresh 373 gears, Lt1 backing plates, 3 channel ABS. Less than 50 miles on gears, less than 500 miles on the whole rear. This rear is certainly not junk. Check out www.drivetrainspecialists.com They're known for some pretty good stuff.


Steve

 

i have a moser 9 inch with 3.70 gears, spool, welded on relocation brackets, billet 1350 pinion yoke, and 3 inch studs. i am less than 5 hours from st. louis. let me know on here or give me a call 219-677-2509

 

SABLT194: I'd rather do a trade in person. I'd rather not lose money to shipping... If I don't find what I'm looking for, I'll consider it.

shady93z: sending you a PM shortly.