Turn Key 350 Engine + 200 4r Tranny... $1200 obo...
Turn Key 350 Engine + 200 4r Tranny... $1200 obo...
I just pulled the 350/2004r out of the monte project I bought... Engine runs good but unfortunately I don't know anything about it... the previous owner was clueless except to say that the owner before him swapped the 350 in...
It runs decent but since I know nothing about it I would recommend at least pulling a head and inspecting it... I've never even pulled a VC off it...
It has an Accel HEI distributor, edelbrock carb, intake, air cleaner, and valve covers...
It is 100% complete from starter to distributor... I pulled it with the fan attached and spark plug wires still on the plugs... just needs to be dropped into something or tore down for a rebuild...
I noticed a slight oil leak from the back of the valve cover on the drivers side and there were a few drips on the floor under where the starter is... I haven't looked to see where that was coming from...
The tranny seems to shift fine and has no obvious problems... however it should probably be inspected too...
Asking $1200 o.b.o, and I will not ship it... pick up only... I'm located in Nashville, TN...
I would guess it is probably worth a tad more, especially with a 200 4r in the deal, but since I know nothing about the internals of the engine, I don't see how I can ask for much more...
Here are a couple pics... I have not had internet at home for almost two weeks and won't have it at home until next monday... I can take some pics of the engine on the stand but may not be able to post them until monday evening...
-Garrett
814-598-2501
glr7495@cs.rit.edu
P.S. I have a great palette built to haul engines that I could give to ya to haul it for $40... and also have the radiator from the car... whoever buys the engine/trans can have it for free...
Pics:
----
http://www.rit.edu/~glr7495/newcar/newcar6.jpg
http://www.rit.edu/~glr7495/newcar/newcar7.jpg
It runs decent but since I know nothing about it I would recommend at least pulling a head and inspecting it... I've never even pulled a VC off it...
It has an Accel HEI distributor, edelbrock carb, intake, air cleaner, and valve covers...
It is 100% complete from starter to distributor... I pulled it with the fan attached and spark plug wires still on the plugs... just needs to be dropped into something or tore down for a rebuild...
I noticed a slight oil leak from the back of the valve cover on the drivers side and there were a few drips on the floor under where the starter is... I haven't looked to see where that was coming from...
The tranny seems to shift fine and has no obvious problems... however it should probably be inspected too...
Asking $1200 o.b.o, and I will not ship it... pick up only... I'm located in Nashville, TN...
I would guess it is probably worth a tad more, especially with a 200 4r in the deal, but since I know nothing about the internals of the engine, I don't see how I can ask for much more...
Here are a couple pics... I have not had internet at home for almost two weeks and won't have it at home until next monday... I can take some pics of the engine on the stand but may not be able to post them until monday evening...
-Garrett
814-598-2501
glr7495@cs.rit.edu
P.S. I have a great palette built to haul engines that I could give to ya to haul it for $40... and also have the radiator from the car... whoever buys the engine/trans can have it for free...
Pics:
----
http://www.rit.edu/~glr7495/newcar/newcar6.jpg
http://www.rit.edu/~glr7495/newcar/newcar7.jpg
Thread
Thread Starter
Forum
Replies
Last Post
ro2207
LT1 Based Engine Tech
14
Dec 4, 2014 06:18 PM
formula79
Automotive News / Industry / Future Vehicle Discussion
26
Aug 5, 2002 12:21 PM



