TPI Partout; Aluminum Heads, Dyno Don Headers, etc...
#1
TPI Partout; Aluminum Heads, Dyno Don Headers, etc...
Tearing apart my 305 LB9 and wont need the TPI setup or heads anymore.
TPI setup; $255 Shipped
- Ported/siamesed Plenum
- Runners
- Ported Lower Base
- Fuel Rail w/injectors
- Throttle Body w/Air Foil
- TPI Snorkel w/lower Filter Assembly and MAF
- Stock Single Fan w/motor $40 Shipped
Aluminum L98 Heads; these are the 113 castings with D-shaped exhaust ports. Heads should be off tomorrow. Car ran strong with them, but will have them checked out just in case. $400 Shipped obo
Extra TPI Stuff;
- Plenum: In the process of being polished, I stopped sanding at 320grit. $55 Shipped
- TPI Runners w/Cold-start: Kinda beat up. $40 Shipped
- TPI Snorkel w/lower Filter Assembly $45 Shipped
Also selling a set of "Dyno Don" 1 3/4 Headers with Ypipe. $585 Shipped obo
TPI setup; $255 Shipped
- Ported/siamesed Plenum
- Runners
- Ported Lower Base
- Fuel Rail w/injectors
- Throttle Body w/Air Foil
- TPI Snorkel w/lower Filter Assembly and MAF
- Stock Single Fan w/motor $40 Shipped
Aluminum L98 Heads; these are the 113 castings with D-shaped exhaust ports. Heads should be off tomorrow. Car ran strong with them, but will have them checked out just in case. $400 Shipped obo
Extra TPI Stuff;
- Plenum: In the process of being polished, I stopped sanding at 320grit. $55 Shipped
- TPI Runners w/Cold-start: Kinda beat up. $40 Shipped
- TPI Snorkel w/lower Filter Assembly $45 Shipped
Also selling a set of "Dyno Don" 1 3/4 Headers with Ypipe. $585 Shipped obo
Thread
Thread Starter
Forum
Replies
Last Post
Brandon Wittmer
General 1967-2002 F-Body Tech
0
12-07-2014 12:15 PM
chevroletfreak
LT1 Based Engine Tech
202
07-04-2005 05:00 PM