Hey guys been slowly cleaning out the warehouse and found a set of used T&D 1.6 shaft mount rockers intake/exhaust. However I have not found the stands for them. These were on a set of AFR 220 LT4 heads. I don't know what the stands would cost so I'm open offers for these. I will try to get a pic of them soon when the battery on the camera charges.

 

I'd make an offer, but it would kinda depend on what those stands cost. I'll look around and see if I can find anything.

Called T&D, guy spoke fast, but sounded like $171 for the stands.

-Dustin-

 

as promised....





Not looking to make a bunch off these, hopefully someone can get some shaft mount rockers for a killer deal! Also they've been stored in tuperware containers with oil. No Rust!

 

are these a bolt in for an lt1 head with head studs?

 

Yes these are made for LT1 heads. You remove your rocker studs and bolt the stands that I do not have to the head. Then these mount to the stands.

 

Ttt :d

 

For everyone wondering or thinking that this is too much offset, let me tell you again. There is no additional offset. the intake is standard .450 offset for AFR 210,220's. I'm attaching a picture to show.

As you can see, the vavle spacing is greater on an AFR head, which requires the .450 offset so that you can use standard lifters and NOT offset lifters. I've had all kinds of offers, First person that paypals $250 gets em shipped FedEx

 

call t&d and ask them,.450 offset rocker takes a .180 offset lifter.