Some projects gotta go!
Some projects gotta go!
I have too many projects and some have to go. I'm entertaining offers on the following.
LT1 complete with everything and A4 out of a '97 Z28 with 60K miles.
1980 Camaro Coupe that the LT1 and A4 was going to go into.
Complete Z28 spoiler set, fender vents, and functional air scoop with solenoid that was going on the Camaro.
1983 21' Sea Ray V207 bowrider that is completely disassembled to repair rot in floor and transom. Hull is built like a tank. Sitting on a dual axle trailer. Powered by a 200 Mercruiser (305cid GM block) with Alpha I MR outdrive (350 hours), power steering, Bennett trim tabs.
Tons of new parts that were to be used while putting the boat back together.
New risers
shift cable kit
all seals, gaskets, and hardware
prop
remote oil filter kit
remote oil drain kit
deep well thin walled socket used to change shift cable
engine alignment tool
Guardian flush system
I'll get a better list together when I get a chance.
LT1 complete with everything and A4 out of a '97 Z28 with 60K miles.
1980 Camaro Coupe that the LT1 and A4 was going to go into.
Complete Z28 spoiler set, fender vents, and functional air scoop with solenoid that was going on the Camaro.
1983 21' Sea Ray V207 bowrider that is completely disassembled to repair rot in floor and transom. Hull is built like a tank. Sitting on a dual axle trailer. Powered by a 200 Mercruiser (305cid GM block) with Alpha I MR outdrive (350 hours), power steering, Bennett trim tabs.
Tons of new parts that were to be used while putting the boat back together.
New risers
shift cable kit
all seals, gaskets, and hardware
prop
remote oil filter kit
remote oil drain kit
deep well thin walled socket used to change shift cable
engine alignment tool
Guardian flush system
I'll get a better list together when I get a chance.
Thread
Thread Starter
Forum
Replies
Last Post



