64cc World Products Sportsman heads
comp 1.5 full roller rockers
comp 977 springs
new valve guides
2.02/1.6 valves
fully assembled ready to be bolted on.
straight plug
just freshened up 2 months ago.
$1000obo

355ci "010" fresh block.
HE pistons, stock crank/rods
fresh bearings/freeze plugs
gear drive timing setup
280AR solid roller cam
crane 11522 solid roller lifters
comp pushrods
melling high volume oil pump
shortblock has over 2500 into it as of now with machine work and new parts.
155 compression across the board with WP heads, 50psi oil pressure @ 2k cruising. less than 300 miles since full rebuild.
will take $1500obo

Torker 2 sbc intake - 50

Super victor sbc intake - 100

1" spacer - 10

~15' of -8AN steel braided line with some fittings - 70

holley dead head regulator, -8AN feed lines, holley 4150 750cfm DP - 350

mallory unilite ignition (dist, coil, 2x wires, resistor box) - 150

summit 4n1 tach (oil pres, voltage, coolant temp, RPM...w/ sending units) - 75

th350 tranny & converter(stock rebuild, include cooler/lines) - 450

oil/fuel pressure safety switch - 10

perimeter bolt valve covers - 20

hedman 1 5/8 mid lengths - 50

3" piping lot of straight, couple mandrel bend stuff - 75

dynamax 18" bullet mufflers - 70 a piece. (have 2)

holley black fuel pump - 70

ford 8.8 rear end (from fox, stock, 3.08) - 150

alternators (1 LT1 stile serp belt, 1 V belt sbc style) - 50 a piece

moroso elec water pump - 125

15" electric fan - 50

large radiator - 125

B&M quicksilver shifter - 125

universal drive shaft loop - 50

4150 plate style nitrous kit(no jets) - 325



have 88 rx7 shell ready to go, full interior, sunroof w/ no leaks, 3 spare rims as pictured in sig, additional guage cluster. can include LT1/LS1/SBC installation kit with it for nominal fee, please email me at matrixghost@hotmail.com for more info if interested.


***none of this includes shipping. i will deliver in st. pete, FL if your spending more then 100. otherwise i can mail it to you, or you can come get it from me.

 

can you send me pics of the 8.8 rear end? still work? badazcamaro@aol.com

 

i would like pics of block plz