RAM Power Grip and Spec Billet flywheel
RAM HDX and Spec Billet flywheel
1 ram HDX clutch Rated at 425HP: with about 500 miles on it. Never seen over 2,000 rpm, Never ran hard because I purchased a flywheel that was 0 balanced. ( not good with a stock LT1!!) 250.00 Shipped
Last edited by BLWNLT1; Oct 27, 2009 at 12:29 PM. Reason: wrong description
just thinking, i dont think it would handle a 383 and 150 shot. i need a clutch bad tho and im about broke from rebuilding the motor again. alot of unexpected costs i had to pay from the last builder screwing it up. i was suppost to pay about 1500 for labor and ended up paying right at 4000 cuz of the idiot place that did it the first time. sorry thing is the motor only lasted 6 months after he did it before the crank bearing screwed the bottom end and then a cam and lifters along with alot of other stuff. he also charged me for a zoom racing clutch and install and found out from the new rebuild that it isnt even in the car, just a stock clutch. go figure. but my tob is about to go out and knocking around bad. doesnt sound good
Last edited by nick3; Oct 29, 2009 at 09:01 AM.
Wow sounds like alot of bad luck. I got a good surprise this morning when My builder gave me the cost for work done for me
This is what he did
VAT the block a few times
Balance rotating assembly (1 piece of Mallory)
1/4 fill block
Line bore and hone
Torque Plate hone
New cam bearing
Total Seal Piston rings supplied by shop
Coyles Dual ROller timing chain supplied by shop.
Short block assembly
1,8xx.xx
WOW
Damn near choked on my breakfast taco.
This is what he did
VAT the block a few times
Balance rotating assembly (1 piece of Mallory)
1/4 fill block
Line bore and hone
Torque Plate hone
New cam bearing
Total Seal Piston rings supplied by shop
Coyles Dual ROller timing chain supplied by shop.
Short block assembly
1,8xx.xx
WOW
Damn near choked on my breakfast taco.
Thread
Thread Starter
Forum
Replies
Last Post
stockssn2o
Parts For Sale
14
May 25, 2015 08:54 AM









