Parting out 1997 trans am ws6
Thread Starter
Registered User
Joined: Jul 2004
Posts: 179
The pcm is odb2, and i was dumb and ended up cutting away a few parts of the harness when i was clearing out the damaged sheet metal. I kept the engine sensor wiring mostly intact, so if that's all you care about i may be able to help.
Thread Starter
Registered User
Joined: Jul 2004
Posts: 179
Thread Starter
Registered User
Joined: Jul 2004
Posts: 179
mailed you.
Also, the LCAs have around 40k miles on them, i never did any twisty racing so they never got stressed that much.
Also, the LCAs have around 40k miles on them, i never did any twisty racing so they never got stressed that much.
1) I would love to take the rear axle bump stops ( they look like this , http://www.fbody.com/tech/details.cgi?id=23 )
and how many miles on the LCAs ?
If you have the bumpstops please email me at cadek1@comcast.net
also some other misc things I could use
2) wiper arm cover - this is the small (6") plastic piece covering wiper arm nut, I need the passenger side one.
3) stock radio plastic power button
4) if you want to separate, then the passenger side power windows/power locks panel panel, I don't need the whole door panel though.
5) cruise control cable that goes to the throttle body
and how many miles on the LCAs ?
If you have the bumpstops please email me at cadek1@comcast.net
also some other misc things I could use
2) wiper arm cover - this is the small (6") plastic piece covering wiper arm nut, I need the passenger side one.
3) stock radio plastic power button
4) if you want to separate, then the passenger side power windows/power locks panel panel, I don't need the whole door panel though.
5) cruise control cable that goes to the throttle body
Thread Starter
Registered User
Joined: Jul 2004
Posts: 179
Ha, i dont think i've ever seen that before 
Is that screwing into the same holes as the tunnel cross-brace?
On mine, the middle of the exhaust pipes was held up by a bracket/square rubber piece that attached to the passenger side of the transmission tailshaft.
Is that screwing into the same holes as the tunnel cross-brace?On mine, the middle of the exhaust pipes was held up by a bracket/square rubber piece that attached to the passenger side of the transmission tailshaft.
Thread Starter
Registered User
Joined: Jul 2004
Posts: 179
Updated picture of LCAs and added some new items to the first two posts:
billet aluminum catch
ES poly transmission mount
ES poly torque arm bushing
rubber transmission mount
msd ignition coil
billet aluminum catch
ES poly transmission mount
ES poly torque arm bushing
rubber transmission mount
msd ignition coil
Last edited by kyle97; Sep 22, 2008 at 11:13 PM.
