New 406 SBC short block FS (MI)
#1
New 406 SBC short block FS (MI)
I'm selling my 406 I was building for my Camaro before I sold it.
I'ts a new World Products Motown block. 350 sized mains, large diameter cam, 4.155 bore
Eagle 4340 forged crank 3.75" stroke
Eagle 6" H-beam rods
Arias N20 500 pistons (23 degree) See spec sheet below.
Hellfire rings
Comes with bearings
The block is a factory blemish block. It has a casting flaw on the outer edge of the deck. I had it checked out by Enginecraft and it was fine, nothing critical. See pic below.
The block is fully machined, has the crank sitting in it, cam bearings are in, and ready for assembly besides gapping rings. Pistons are hung on rods.
Looking to get $3200 obo
I'ts a new World Products Motown block. 350 sized mains, large diameter cam, 4.155 bore
Eagle 4340 forged crank 3.75" stroke
Eagle 6" H-beam rods
Arias N20 500 pistons (23 degree) See spec sheet below.
Hellfire rings
Comes with bearings
The block is a factory blemish block. It has a casting flaw on the outer edge of the deck. I had it checked out by Enginecraft and it was fine, nothing critical. See pic below.
The block is fully machined, has the crank sitting in it, cam bearings are in, and ready for assembly besides gapping rings. Pistons are hung on rods.
Looking to get $3200 obo
Thread
Thread Starter
Forum
Replies
Last Post