These heads were bought as new bare castings without guides, valve seats, etc. for over $550 each. Here is a link to them @ paceparts. They've had full bronze guides installed, been fully ported, and presently have some Manley 2.02/1.60 Race-Flo 5/16" valves in them with teflon seals & Comp. locators.

This is what the Nascar guys used to run back in the day & is enough to make around 600-620hp NA. Offhand I can't recall the chamber volume, but I believe they're in the 5Xcc range & can obviously be altered a bit as necessary.

Flowsheet
Intake
Exhaust

As they are, the castings are over $1100 alone, they have around $1k in porting and machinework labor, and around $300 in parts, or ~$2400. They're just sitting however & I'm moving, so make me an offer I can't refuse

phil @ advancedinduction.com (remove spaces)

Thanks,

-Phil

 

mail sent.. Intrest in those heads + your port work too. I didnt put in an offer because im not sure if those heads were good with my cam.
let me know though phil.

 

Recieved/Responded


I suppose I should mention that I'm not looking to get $2k+ from them. I really only want what the castings & parts cost out of them ~$1600... so eh, make an offer I suppose.

 

Suppose I'll top this while I'm thinking about it