i got heads,short block, valve train

ok this is the info on the heads
the invoice from the heads said--
ladds porting service
2 assembled heads 16 new cc springs

disassemble, clean
install new k-line bronze guides
comp. valve job
radius & blend pockets
true up deck deck surface
final clean & assemble
cc 1 camber = 55.3 cc

1.700 @115 lbs
1.190 @340 lbs = .510 lift
1.105 @ coil bind=.085 clear

heads are fully ported with comp cam springs

here is the info on the short block

it is a 350 lt1 bored .30 over to a lt1 355
motor only has like 2300 miles and it runs great!!!!!!!!
all all all the machine work by bill colman and the colman brothers
balanced and blue printed
comp cam .274 .510
new timing chain and sprokets
high flow oil pump
all the rods have been redone with the crank
pistons are custom speed pro 9.1 forged pistons
motor with heads are 9.1 compression great for nos or blower

here is the valve train infor

1.5 gold crane roller rockers
forged pushrods by comp cam
forged lifters by comp cam
all this stuff cost me over $800

ok call me at 443-392-1242 (aj)

andrew wesolowski
1853 church street
glen rock pa, 17327

some one was going to buy the heads and then they did not want to pay for shipping so you will need to install new head gaskets and head bolt i have AFR head bolts and if i can find them i will give them to you. so you just have to get new heads gaskets and swap all parts over and you will be ready.

I WISH I DID NOT HAVE TO SALE IT BUT I GOT A NEW HOUSE AND I AM GETTING MARRIED SO $2400 FOR EVERYTHING

 

How much for just the heads and do you have any flow numbers?

 

$650 shipped i have no flow numbers

 

Good luck selling them without flow numbers.

 

how much for just the short block and do you have pics?

 

$1400 i sent out all my pics